Products

Disk Manufacturing Module

Disk Manufacturing & Screening Module (DMM)

A multi-threaded, multiple-HBA, multi-drive screening and testing tool for HDDs and SSDs. Test processes are built from a graphical user interface — no programming or scripting is required. The current product page says a complete test process can be set up in as little as five minutes.

SCSI Toolbox describes DMM as joining a decade of real-world drive testing experience to bring a testing tool to the HDD manufacturing and integration marketplace. It allows you to:

  • Confirm that the proper drives are in the subsystem
  • Download new drive firmware if needed
  • Set all mode pages to your standard
  • Set block size and capacity
  • Format
  • Log and track all error information
  • Run any type of test, or sequence of tests, at full bus and device speeds
  • Log all process activities, drive information, and any errors to an Access database

Defining the test process

Test processes are divided into three sections: Pre-test, Test, and Post-test.

Pre-test can screen attached drives by the following qualifiers described on the current DMM page:

  • Drive vendor (for example, a required vendor code such as “SEAGATE”)
  • Drive product (for example, a required product code such as “ST32123FC”)
  • Drive firmware version — reject the drive, or download the proper firmware file
  • Number of primary (factory) defects
  • Number of grown defects — reject the drive, or issue a low-level format to try to clear them
  • Drive mode pages — set values to a “golden” drive setting
  • Drive block size and capacity

DMM scripts can also be run unattended with the Automated Manufacturing Engine.

DMM sequence files and sample scripts · Pricing and how to order